再生品ポータルサイトの表示をカスタマイズできる
お客様の詳細情報を管理し、eストアチームからの回答が短時間で届くようになる
お近くのキーサイトの営業担当者に問い合わせができます
製品価格や在庫の最新情報をお届けします。Oscilloscopes and Triggering
Back to overview of articles from the Oscilloscopes Basics series
To stabilize a waveform displayed on your oscilloscope, a trigger is needed. A specific, pre-defined event occurs – for example, an edge that rises beyond a certain voltage level – that lets the oscilloscope start a trace. Once it’s completed, the scope waits for it to occur again. This process is also called a sweep.
An untriggered display would be virtually useless because the waveform is not shown as stable on the display: It is the trigger that pinpoints a specific section of the signal in question and synchronizes individual repetitions of the wave to create a coherent image.
The trigger controls let you set the event to start recording the waveform you’re interested in. Here are some of the most common triggering types:
Edge triggering
As in the example mentioned above, edge triggering is one of the most straightforward triggering modes. The trigger event defines a threshold value, which is activated when the voltage level surpasses it. It is possible to trigger on either a rising edge or a falling one.
Glitch triggering
The glitch trigger targets glitches and other infrequent and unexpected events. The trigger here is any event shorter or longer than a specified time span, in other words its width. Glitch triggering catching many errors that could otherwise be missed.
Pulse-width triggering
This type of triggering is not dissimilar to glitch triggering in that it also zeros in on specific widths of pulses. However, the widths are more general and not linked to a specified time span. Polarity is available for definition as well. You can also set the horizontal position of the trigger. This pushes what happened just before and after the trigger event onto the display, a feature especially useful when looking for causality relationships in the signal. Setting horizontal delay to zero, will center your trigger event in the middle of the screen along the horizontal axis.
Advanced Triggering
There are many more triggering types available, getting more complex as the respective device under test does. There is also no requirement to trigger on the signal itself – you may just as well trigger on a related signal.
For more information, have a look at our Keysight YouTube channel (LINK) for our series on triggering and common measurement errors.
However, if you still look for technical advice, contact our technical hotline (LINK to. The US 1st Contact) first.
Alternatively, find your very own oscilloscope on the Keysight Used Equipment Platform (LINK). Whether its triggering or other functionalities, used Keysight often have better specifications at lower prices than comparable new models, offering fantastic value for money.
Contact us (LINK) for a personalized purchase recommendation.
